Bimba SPCS Manuel d'utilisateur télécharger pdf (Page 7)

2014.01.23 rev4 7

2. Opening SPCS USB Interface

e. Click on the Bimba SPCS button in the Start Menu,.

• Communication: Select the Select Port dropdown window: Select a Com Port and click the Enable

Communication check box. If communication is established the remaining screen selections will be-

come available. You may have several Com ports from which to choose – you may have to repeat the

selection process above to nd the correct one.

(All selections are “grayed out” until communication is established)

• Select Signals – Both command and feedback signals are selected by clicking the appropriate button

– 0 to 10V is the default value.

• Enter cylinder bore size and rod diameter using the up or down arrows. (Rodless cylinders: set rod

size at zero)

• Select Port Communication based upon your installation.

• After entry click

The initial setup parameters, as well as those on the Basic Setup and Advanced Setup screens de-

scribed below can be saved and reloaded for further adjustments or to program another valve. Upon

clicking the “Save Conguration” button a window will appear that allows you to enter a le name and

save it.

Click this button to save a new program or a program loaded from an existing le to

the valve.

Note: Mouse over “Tool Tips” are provided for each selection.

Click this button to load previously saved programs. A window will appear asking you

to select and load a program.

Initial Setup Screen

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Pas de commentaire

Bimba SPCS Manuel d'utilisateur Page 7