Bimba STP-10 Manuel d'utilisateur télécharger pdf (Page 24)

STP-10 Hardware Manual

DRIVE

Power

Supply

–

Proximity

Sensor

output

–

CW LIMIT+

CW LIMIT-

Connecting a Potentiometer to Analog Input 1

Analog Inputs

The STP drives feature two analog inputs. Each input can accept a signal range of 0

to 5 VDC, ±5 VDC, 0 to 10 VDC or ±10 VDC. The drive can be congured to operate

at a speed or position that is proportional to the analog signal.

A shielded cable is recommended for electrically noisy environments.

Use the IQ

Stepper software to set the signal range, offset, deadband and lter fre-

quency.

inside drive

AIN1

AIN2

GND

DB-25 Connector

Signal

Conditioning

Signal

Conditioning

1-10kW

pot

ccw

DRIVE

GND

AIN

+5V OUT

AIN2

If the sensor output goes low at the limit, select the option “closed” (in the software). If the output is open, or high voltage, choose

“open”.

Other sensors have sourcing outputs. That means that current can ow out of the sensor output, but not into it. In that case, wire

the sensor this way:

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 38 39

Pas de commentaire

Bimba STP-10 Manuel d'utilisateur Page 24